ICs & ChipsCode 7c143b87d7
LM3914
Analog Controlled LED Driver IC
- Delivery in 2 to 4 working daysFree in Islamabad & Rawalpindi above Rs 5,000
- Cash on deliveryPay when your parcel arrives
- 7-day checking warrantyDead-on-arrival items replaced
- Packed with careAnti-static & padded packaging
Highlights
- Analog Controlled LED Driver IC
- Both Dot/Bar mode available
- Can be cascaded to control upto 100 LEDs
- Available in 18-pin DIP package
- Crude Battery level indicators
- Low cost monitor devices
- Digital gauges
- Electronic displays
Specifications
- Pin Number
- Pin Name
- 1 and 10 to 18
- LED1, LED2, LED3…..LED10
- Number of controllable LEDs
- 10
- Operating Voltage
- 3V to 18V
- Input Analog voltage range
- 1.2V to 12V
- LED sink current
- 2mA to 30mA (programmable)
About this product
Where to use LM3914?
The LM3914 is an analog controlled, meaning it can control (turn on or off) 10 LED lights based on an analog input voltage. This IC eliminates the need for microcontroller and programming and also reduces the hardware required to control 10 LEDs.
The analog input voltage can vary from 3V to 18V and the LED current can be limited by simply using a single resistor on pin 7 (Ref Out). The IC also has two operating modesand, also more than one IC can be cascaded to control upto 100 LEDs. Since the LEDs can be controlled without any flickering and flawlessly with equal brightness these IC’s are commonly used in visual alarms and other metering/monitoring applications. So, if you are looking for an IC to driver your bar LED lights or other sequence of 10 LED then this IC might be of interest to you.
How to use a LM3914?
The advantage of using LM3914 is that it requires minimum hardware and can be easily set up. We simply have to connect the 10 LEDs to the IC, set the reference voltages for input voltage and limit the current through the LED and we are all set
Simply power the IC using the V+ and V- and the analog signal voltage is given to pin 5. Here we have used 9V to power the IC to monitor an analogy voltage of 0-5V. Always note that the voltage used to power the IC (here 9V) should be at least 1.5V more that the monitoring voltage(here 5V).
Since we are monitoring 0-5V here, the low reference voltage (pin 4) is set at 0V and the high reference voltage (pin 6) is set to 5V. As you might have noticed we have connected all the 10 LEDs directly to the IC without any current limiting resistor this is because the IC…
