Skip to content

Cash on Delivery all over Pakistan · Free delivery in Islamabad & Rawalpindi above Rs 5,000

PakCircuit
1 Meter 10pcs Hard Jumper Wires 100cm Spiral Wrap Wires 10 Core Cable
Wires & Jumper CablesCode 5c6c5c70f9

1 Meter 10pcs Hard Jumper Wires 100cm Spiral Wrap Wires 10 Core Cable

Hard Jumper wires have connector pins at both ends, allowing them to be used to connect two points to each other without soldering.

Rs 140
In stock Price updated 15 Nov 2026
Total: Rs 140
  • Delivery in 2 to 4 working daysFree in Islamabad & Rawalpindi above Rs 5,000
  • Cash on deliveryPay when your parcel arrives
  • 7-day checking warrantyDead-on-arrival items replaced
  • Packed with careAnti-static & padded packaging

Highlights

  • Pin to Pin configuration
  • Available in minimum 1 meter (100cm) lengths and longer
  • Individual cores or wires can be separate for multi-purpose use
  • Each core in cable is individual separate color!
  • 10 thin wires packaged in a spiral cable wrap
  • Strip off about 1/4- to 1/3-inch of insulation from each end.
  • Bend the exposed ends of wire at a right (90-degree) angle.Use your needle-nose pliers to do this.
  • Dial the gauge to 20 or 22 (depending on what

About this product

Hard Jumper wires have connector pins at both ends, allowing them to be used to connect two points to each other without soldering. These hook up wires are mostly use with breadboards and other prototyping tools/ boards. And make it easy to customize a circuit according to your requirements.

A breadboard wire establishes an electrical connection between two points in a circuit. Jumper wires can be use to modify a circuit or to detect problems in a circuit. These are specifically male to male connection wires .

It is tougher than a stranded conductor , but rigid and less flexible than a stranded conductor. Solid conductors are more likely to break if subjected to frequent flexing than stranded conductors. To help you visualize its rigidness, it is more flexible than a solid conductor, but less durable.

Pin to Pin hard wires are sometimes used to bypass a portion of the circuit (such as a stretch of wire or a switch) that DOES NOT contain a resistor and is suspected to be bad. In other words, you can use a jumper wire to provide a direct path for current to pass through.

Specifications of 1 meter Hard Jumper Wires :

•

Cut the wire to the length you need, using a wire-cutting tool.If you need, say, a 1-inch jumper wire, cut a length of wire that is at least 1-3/4 inches long. So you leave room to strip some insulation off each end. It’s better to cut a longer length of wire and trim it down if you need to than to cut a shorter length of wire and find that it’s too short for your circuit.

•Strip off about 1/4- to…

Related searches

You may also need

More Components →